Open up the back cover, take out the battery, and then insert it into the battery container again. The following steps describe how to quickly reset Reolink Go by pressing the Reset button (the camera will return to factory default settings). Run the Reolink App, scan the QR code, and set up the camera again. You’ve successfully factory reset your camera. Press and hold for several seconds until you hear the voice message “Factory reset succeeded!”, then release the Reset button. Insert a reset needle into the reset hole of your camera. Once the reset is done, your camera will return to factory default settings. Follow the following two steps to quickly reset the camera by pressing the Reset button. How to Reset Reolink Argus, Argus 2 and Argus ProĪpplies to these models: Reolink Argus, Argus 2, Argus Pro. You can log in with the default username and password (the default username is “admin”, and the default password is blank/no password). For C1, C2, C1 Pro, and C2, it will start to pan & tilt which means it was reset.Īfter reset, your camera will return to factory defaults. The camera will give reminders of reset.įor Reolink Keen, it will sound the prompt “Factory reset succeeded”. Press and hold for about 10 seconds, then release it. Insert a pin or needle into the reset hole (as shown in the picture). To quickly reset cameras like Reolink Keen, C1, C2, C1 Pro, and C2 Pro in three steps. How to Reset Reolink Keen, C1, C1 Pro, C2, and C2 ProĪpplies to these models: Reolink Keen/C1/C2/C1 Pro/C2 Pro. The default username is “admin”, and the default password is blank (no password). After reset, your camera will return to factory default settings, then you can log in with the default username and password. Keep holding for about 10 seconds then release the Reset button. Press the Reset button and hold it (don’t release), then power on the camera while pressing the Reset button. Follow the step below to reset your bullet or dome cameras to factory defaults by pressing the Reset button. Keep in mind that the actual interface may vary depending on specific models. The instructions come from Reolink’s official technical documents, including the pictures. In this guide, we will show the reset procedure for various models of Reolink security cameras such as regular IP cameras, PTZs, WiFi cameras, etc. There are basically two ways to reset the lost password on a Reolink camera: restore it on Reolink software if the camera is still connected to the recorder or, the easy way, press the reset button on the camera and recover the password right away. If you forgot the password of your Reolink IP security camera, you can perform a hard reset and bring the password and the whole device to factory settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |